![]() nsloopup isn't working either, it times out.ġ0.0.0.0/24 dev em1 proto kernel scope link src 10.0.0. For some reason though I have to assign a temporary IP via command line, shouldn't that file do that automatically?Īlso, while I can ping 8.8.8.8, I can't ping, even after adding it in the interfaces file. Another problem I had was my router's gateway was actually 10.0.0.1, I forgot because I'm used to 192.168.1.1. Thanks! After some changes I am able to ping my router and 8.8.8.8. ![]() Is there something I'm missing? I don't have much experience with networking. Now I can't see the IP4 address in ifconfig and it says "Network is unreachable" when I ping the router. I took note of my computer that is connected to this network properly, so I changed /etc/networks/interfaces to auto em1 It allows connections to the FortiGates loopback IP address without depending on one specific external port, and it is therefore possible to access it through several physical or VLAN interfaces (redundancy). This would also work only if you already have a default route in your routing table. I see that you have the default-information originate statement as well. The network statements under router ospf do not include the loopback interface. When I ping my router, I get "Destination Host Unreachable"Īnd when I ping, I get "Unknown host "Īnd when I ping a computer on this network, I get "Network is unreachable" 2 Answers Sorted by: 2 The loopback interface in R1 is not in the OSPF domain. To start, I figured out that instead of "eth0" I have "em1", and I got it so I now see em1 in ifconfig. ![]() I just installed Ubuntu Server yesterday on my old laptop. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |